Pro|HOMEPAGE :: Information You Can Use

Show Content From The Last

Total Records: 119
Page 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12

PTCs Wildfire 5.0 Quick Reference Card

www.ptc.com - This is an 8 page color PDF suitable for printing, laminating, framing, etc. Just in case you forget where the Model Tree or Browser are located :)

Submitted about 1 week(s) ago

WF5

1
0
Vote

A Better Way to Select Curves For Projecting

www.prohomepage.com - Here is a new way to quickly select hundreds or thousands of curves to project in one single feature. As long as your IMPORT feature with the curves is clean, this should work nicely. Shown in Sheetmetal mode, but works on Solids or Surfaces too.

Submitted about 12 week(s) ago

WF5

1
0
Vote

Variable Pull Direction Draft

www.prohomepage.com - This is a new feature in Pro/E for WF5. It provides a slightly different Dashboard for Draft creation with a new capability (Sets).

Submitted about 13 week(s) ago

WF5

1
0
Vote

Change to Sketch Dimensioning Behavior in WF5

www.prohomepage.com - Set to us by a fan ... if you are moving to WF5 or have recently moved to WF5, check this out. It is a little thing, but to some, it is a big thing.

Submitted about 17 week(s) ago

None

1
0
Vote

Obtaining the Real Structural Results of Plastic Deformation Using Mechanica

www.ptc.com - See how Pro/ENGINEER Wildfire 5.0 Advanced Mechanica lets you define materials capable of handling plastic deformation.

Submitted about 18 week(s) ago

WF5

1
0
Vote

Customer Spotlight: Exmark Manufacturing (Beatrice, NE)

www.ptc.com - Find out how Exmank Engineering (a division of TORO) used Pro/ENGINEER to simplify its assembly, cut down on the number of parts and reduce time-to-market.